Drilling Mud Shear Pump with High Quality for Sale

No matter onshore or offshore oil and gas drilling/CBM/HDD/Pilling/waste management shearing pump will be widely operated. It can configure drilling fluid with high performance.
 
Issues affecting its performance:
Property of drilling fluid to be compounded. Drilling fluid solids content and working condition. Furthermore, the seal is important issue affecting shearing pump performance too
Main structure:
Including impeller, casing, support base, packing case, shaft, wheel, belt, motor
 

Legal operation:
1)Please make sure connect ground electrode on the power to avoid leakage
2)All inlet and output lines on junction parts should be sealed well. If any leakage on fluid or gas will affect much on pump performance
3)Press the start button to check rotation. If direction is different with arrow on pump please adjust one pair binding post to correct the direction same as arrow marking
4)Checking drilling fluid level make sure inlet line is completely under the level for operation
5)Turn on the motor when it's stable switch on the inlet gate. Also pay attention on pressure gauge if there is no pressure or pressure fluctuation is too high please release air
6)Feeding bentonite into hopper as 40KG per minute also check everything is ok or not 
7)Rotate the pump coupling with hand to check if any unusual noise
 
Maintenance:
1)Clean the pumps and pipelines with clean water to avoid blocking impeller channel and nozzles
2)The first operation or operate shearing pump after long time we need to lubricate seal case and bearing case
3)Before running shearing pump we must open the inlet and output gate
4)Feed 10~20ml lubrication grease in bearing case every week. Feed 10~20ml lubrication grease in seal case very week
5)Adjust seal case cover every week if we can't adjust it anymore then we need to replace two packings. 2 ends of new packing request 45°degree. Make sure packings touch each other tight on the bearings when install them every 2 packings should be 90-150° degree direction
6)In cold seasons if pump will be stopped long line please screw out the nut under pump case release drilling fluid to avoid freezing
 
Warning:
1)Clean pump with clean water after stopping shearing pump
2)In winter when finish operation please release all fluid out of pump
3)Pay attention on pressure gauge if there is no pressure or pressure fluctuation is too high please stop pump and release air
4)Don't use the shearing pump transfer drilling fluid with large quantity sand
5)If there is leakage when pump turned off we need to adjust packing cover. Please adjust 2 nuts at the same time but not one nut to avoid cover bias and heat after abrasion with shaft sleeve

APJQB Shear pump specification